Hello

I'm writing to get some help regarding USB device on my?CH32V203G6U6

I'm porting/implementing HID touchscreen and found that on Linux all works fine, I have multitouch but issue is on Windows

I have found that fix was done on Teensy but USB stack is much different for WCH and if some can help me understand and how to change this on WCH USB LIB

This is their fix:

Teensy 4.1 Windows fix

also one part is explained here

Microchip usb_config.h

And I know in WCH USB lfile: usb_core.c (or something else) we need to change it but I'm not so familiar with it so would be nice if someone can help me please

Also my base for doing this was sample from EVT: ch32v20x/EVT/EXAM/USB/USBD/CompositeKM

Thanks

I cant help you with the WCH implementation. You need to figure out that yourself. As far as I know WCH usually evaluates the Requests on bytelevel not on word level.

Anyway the case 0x01A1 means:

bmRequestType? A1:? classrequest on interface (CLASS_ | INTERFACE_)

bRequest? ? ? ? ? ? ?01:? ?means Get_Report? ? ? ? ? (GET_REPORT)

wValue? ? ? ? ? ? ? ? ?0x300? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? (FEATURE_ << 8 | ReportId)

wIndex? ? ? ? ? ? ? ? ?interface no? ? ? ? ? ? ? ? ? ? ? ? ? ? ?(MULTITOUCH_INTERFACE)

wValue? ? ? ? ? ? ? ? ?0x100? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? (INPUT_ << 8 | ReportId)

wIndex? ? ? ? ? ? ? ? ?interface no? ? ? ? ? ? ? ? ? ? ? ? ? ? ?(MULTITOUCH_INTERFACE)

see HID spec page50/51 hid1.2.pdf

in general all this magic numbers without comments in that patch is very bad programming

Hey usbman

You were 100% correct, after your post I have started to search for specific cases in WCH USB lib and found that specific handling is done in usb_prop.c

there is section in?

/*******************************************************************************

* @fn ? ? ? USBD_Data_Setup

*

* @brief ? ?handle the data class specific requests

*

* @param ? ?Request Nb.

*

* @return ? USB_UNSUPPORT or USB_SUCCESS.

*/

RESULT USBD_Data_Setup(uint8_t RequestNo)?

there is part in function

if (Request_No == HID_GET_REPORT)

? ? {

? ? ? /* HID Get Report */

? ? }

is where I added for POC

? ? ? /* HID Get Report */

if (USBbmRequestType == 0xa1 && Request_No == 0x01)

{

????uint8_t *point1 = (uint8_t *)&HID_Protocol_Value[0];

????uint8_t *point2 = (uint8_t *)&HID_Protocol_Value[1];

????

????*point1 = 0x02;

????*point2 = 0x02;

????

????pInformation->Ctrl_Info.Usb_wLength = 2;

????pInformation->Ctrl_Info.CopyData = &HID_Get_Protocol;

}

And it works, I get now normal enumeration of touchscreen and correct touchpoints

Wanna thank you a lot for hint :)