各位大蝦好：

? ? ? ?第一次使用MounRiver做開發，進入調試要70多秒，不知道是否能提高一些速度！實在是太慢了！截圖如下！

Info : WCH-LinkE? mode:RV version 2.9?

Warn :? The debug interface has been opened,there is a risk of code leakage ,ensure that the debug interface has been closed before leaving factory !

Info : wlink_init ok

Info : clock speed 6000 kHz

Info : [wch_riscv.cpu.0] datacount=2 progbufsize=8

Info : [wch_riscv.cpu.0] Examined RISC-V core; found 1 harts

Info : [wch_riscv.cpu.0]? XLEN=32, misa=0x40101105

[wch_riscv.cpu.0] Target successfully examined.

Info : starting gdb server for wch_riscv.cpu.0 on 3333

Info : Listening on port 3333 for gdb connections

Info : accepting 'gdb' connection on tcp/3333

Info : flash size = 448kbytes

Warn : Prefer GDB command "target extended-remote :3333" instead of "target remote :3333"

Info : Padding image section 0 at 0x00001ac4 with 4 bytes

Warn : keep_alive() was not invoked in the 1000 ms timelimit. GDB alive packet not sent! (70210 ms). Workaround: increase "set remotetimeout" in GDB

您好，我這邊測試了幾個程序都是幾秒就可以進仿真的。仿真時注意一下使用的線材，盡量短一些。注意將CLK Speed的速度選擇high。使用評估板再用ADC例程測試一下進入仿真時間需要多久。